Home Server icon   Home Server (2) – Hardware to buy list



In this second post of the “Home Server” series I show you a list of the hardware I have used. Not all of them are mandatory, but depending on the performance you want to achieve it is interesting to use all of the recommended.

HP Microserver Gen8

The main protagonist of the project. These servers stand out because they offer very good service at low cost. You can buy in several models more or less cheap depending on the performance they offer (better CPU, more memory …). I bought the cheapest one and added some improvement (like memory).

The best it has is the low power consumption, it is very silent, supports RAID, supports iLO…

These are a few of its features (as I said correspond to the cheapest model that I bought):

CPUIntel Celeron G1610T Dual-Core a 2.3 GHz
Memory4GB (supports up to 16GB in 2 DIMM slots DDR3)
RAIDSmart Array B120i chip supports RAID 0, 1 y 10
Hard Disk4 x SFF cold-swap SATA drive bays
Network ports2 x Gigabit LAN ports
ILOYES!

HP Microserver Gen8HP Microserver Gen8

SATA Disks

Logically the disk bays come empty. The disks must be bought separately. I bought 2 Seagate Barracuda of 2 TB each to configure them as RAID 1.

Comprar:
2TB Seagate Barracuda SATA disks

SSD Disk

This is optional but I highly recommend (as I did) the use of SSD disk to host operating systems, ESX, virtual servers … and use SATA disks only for data. The performance increases a lot and with the current prices of the SSD discs it is worth it. This would be installed using the port that is reserved in the Microserver Gen8 to install an ODD (Optical Disk Drive) as I will explain in a post later.

Sandisk SSD 250GBSandisk SSD 250GB

SATA Power cable and Data cable

If you finally decide to use an SSD disk, you also need a SATA power cable
Delock SATA power cableDelock SATA power cable

… and a SATA data cable
SATA data cable

Memory

The server comes with 4GB of RAM and, as already mentioned, can support up to 16GB. Expanding it is optional, since to install an ESX (as it falls within the scope of this project), 4GB is the minimum. But to be able to “play” more, create a laboratory, multiple virtual machines, etc … it would be necessary to extend it. I bought an extra 4GB module to have a total of 8GB.
4GB memory module for HP Microserver Gen8

CPU

Also optional. With the one included with this model, for now, I have no problems, but if you are interested in getting more performance you can buy for example:

Intel Core i3-3220T (2.8GHz, 2 cores, 4 threads, 35w TDP, Ivy Bridge)

Leave a Reply

Your email address will not be published. Required fields are marked *